Publicité
TM
SLIM 62 INSTALLATION INSTRUCTIONS
Thank you for buying RC lighting fixtures. Our goal is to design the best quality products to get the job done right. We'd like to hear your comments.
Call the Marketing Department at 888-722-1000 or email: marketing@rclighting.ca
GUARD/ SHIELD INSTALLATION
1. Remove left and right Cover Plates as in figure 1 and
discard.
2. Mount wire guard and/ or poly shield with (4) #8-32 x 1/2"
Stainless Steel Screws. Screws are provided with the
accessory.
Cover Plate
Stainless Steel
Screws
Stainless Steel Screws (4)
Note: Guard and shield may be used together.
FULL CUTOFF/ GUARD/ SHIELD
INSTALLATION
1. Remove (4) Stainless Steel Screws from the Full Cutoff
Hood.
2. Mount wire guard and/ or poly shield over the full cutoff
hood with (4) #8-32 x 1/2" Stainless Steel Screws as shown
in figure 2. Screws are provided with the accessory.
Figure 2
Note: Guard, shield and full cutoff hood may be used together
with (4) #8-32 x 3/4" stainless steel screws (supplied by others).
Note: These instructions do not cover all details or variations in equipment nor do they provide for every possible situation during installation operation
or maintenance.
Figure 1
SLIM56 WIRE GAURD
RAB LIGHTING
3/22/2013
Stainless Steel Screws (4)
Full Cutoff Hood
Stainless Steel
Screws
CLEANING & MAINTENANCE
CAUTION: Be sure fixture temperature is cool enough
to touch. Do not clean or maintain while fixture is
energized.
1. Clean glass lens & fixture with non-abrasive glass
cleaning solution.
2. Do not open fixture to clean the LED. Do not touch the
LED.
TROUBLESHOOTING
1. Check that the line voltage at fixture is correct. Refer to
wiring directions.
2. Is the fixture grounded properly?
SLIM56 POLYSHIELD
RAB LIGHTING
3/22/2013
Publicité
