Settings And Adjustments; Start Menu; Operations Menu - Husqvarna PP 440 HF Manuel D'utilisation

Start menu

The start menu is displayed every time the voltage to the
power unit is switched on. In this menu the user must select
the fuse.
The remote control display shows "SELECT FUSE".
If the available fuse is 32 A, confirm this by pressing the
membrane key marked 'OK". If no 32 A fuse is available, you
can select 25 or 16 A instead by pushing the arrow down. The
display now shows "SELECT FUSE" 25 A or 16 A. Press OK
to confirm the selection.
The display now shows "HUSQVARNA PP-440 HF PRESS
START".

Operations menu

As long as the power unit has voltage but the blade rotation
stands still, the display shows "Husqvarna PP-440 HF
PRESS START".
Before starting, all controls must be turned to zero position. If
this is not done, a message in the display will prompt this
when the start button is pushed. "TURN OFF TRAVEL
FEEDING" or "TURN OFF DEPTH FEEDING" or "TURN OFF
BLADE".
When the blade rotation is started, "XX RPM/ B. YY mm ZZ%
RPM" is displayed, where XX represents the number of
revolutions, B stands for blade, YY represents the
recommended blade size and ZZ the power output in percent
of max. output.
By navigating with the arrow keys, the following settings can
be reached:
• Water coolant
• Select language
• Id power unit
• Time
• Total machine time
• Rotation direction
Water coolant
Select mode AUTO or ON. If AUTO is selected the water
cooling is activated when the blade rotation starts. If ON is
selected the water valve is always open. The water can be
switched of manually with the water tap. The default mode at
startup is AUTO. Selected mode is shown in the display.
Change mode by pressing OK.
10 –
English

SETTINGS AND ADJUSTMENTS

Select language
Using this sub-menu you can set the language you wish to
use on the display.
Scroll using the arrow keys until the required language is
shown. Confirm with 'OK".
Id power unit
The display shows the identity number for the power unit.
Time
The function is used to measure the amount of time a job
takes. The time is counted from when the saw starts working.
Select:
• ON, to enable.
• OFF, to disable.
• RESET TIME, to reset.
Browse with the arrow keys and confirm with "OK".
Total machine time
Here the total operation time of the power unit is shown. The
time is shown in hours and minutes (hhhh:mm).
Rotation direction
Here you can set the rotation direction of the blade. Select
standard or backwards by pressing "OK".