Baby Lock BLE8-SF Manuel D'instructions

Serger Accessories
Shirring Foot
(BLE8-SF)
Instructions
For easy shirring and gathering on lightweight to medium
fabrics using the overlock or chain stitch settings on your
serger.
MACHINE SETTINGS FOR OVERLOCK
Stitch type:
Stitch Width:
Needle:
Stitch length:
Upper nnife:
Differential feed:
Stitch selector:
Sewing speed:
1. The Shirring Foot has an additional groove on the
underside of the foot for gathering.
2. The raised markings on the toe of the foot are seam line
guides. They indicate the needle positions to help guide
your fabric for accurate seaming.
3. Replace the General-Purpose Foot with the Shirring Foot.
See Machine Instruction and Reference Manual for
assistance in removing and replacing the snap-on feet.
LNIS-BLE8-SF
Baby Lock
4-Thread Overlock, 3-Thread
Overlock, Chain Stitch
M-7.5
01 and 02
4
Engaged "UNLOCKED"
2
A
Slow to moderate
www.BabyLock.com
Brought to You by Tacony Corporation
4. Increase the stitch length. A stitch length of 4 is the
recommended setting.
5. Increase the differential feed by moving the lever towards
the number 2. The higher the differential feed the more
the fabric will gather.
6. For best results place fabric to be gathered right side up
under the presser foot and past the grove on the
underside of the foot.
7. Place the fabric up to the needles. Turn the handwheel
3-4 turns to catch the fabric with the needles.
8. Can also be used with chain stich.
9. The foot has tape sewing slots on the front to easily guide
narrow ribbons, elastics and tapes.
® .