Publicité
Operation
Temperature setting and control (EVCO)
The front panel of the thermostat
1.
Compressor operation light
2.
Defrosting light
3.
Energy saving light
4.
Stand-by light
5.
Programming key (service agent only)
6.
Machine On/Stand-by (keep pushed)
7.
Manual defrost (keep pushed)
8.
Light on/off
How to turn the machine in ON / STAND -BY status
•
Press and hold the
•
During the button hold the
How to see and modify the set point
•
Push and immediately release the
•
To change the set value push
•
To memorize the new set point value push the
Automatic defrost
•
The appliance will automatically run defrost cycles.
Note: The cycle starts from the time the appliance is initially powered up.
Manual Defrost:
•
Press and hold the DEFROST
•
The defrost cycle will start immediately and the Defrost
Note: Starting a manual defrost also resets the automatic defrost timer.
How to turn ON / OFF the light:
•
Press and release the
Note: Light logo is present and active only for model with glass door
P2M038STD-Ver1.2
key for 4s, the machine will turn from ON to STAND -BY status and vice-versa.
LED will blink to show status changing.
key, the set point will be showed and starts blinking;
or
arrows within 20s.
button for 3s;
key, the light will switch ON or OFF.
10
key again or wait 20s.
LED illuminates.
GB
Publicité
