FISCHER Profi Plus III Mode D'emploi page 9

Operating and safety precautions
GB
86389-FZ-Fahrradanhänger-Profi-Plus-III-FIS-IM-INT-V03-OEF.indd 9
Place 2 orange reflectors [part no. 9] on the outer
spokes of both of the wheels. Make sure that these
are firmly attached to the spokes.
Screw both wheels [part no. 6] to the base frame
[part no. 2] as shown in the photo.
Tighten the screw positioned on the outside and
attach the screw covers by placing them on the
screws.
Please make sure that the self-locking screw is
properly tightened. Check regularly that the self-
locking screw is correctly seated.
Screw both white reflectors [part no. 8] to the front of
the base frame [part no. 2] and screw the red reflector
to the rear of the base frame by the brackets provided
for this purpose. Use 2 M5x10 fixing screws each for
this.
Screw the lower tow bar part [part no. 4] to the front
of the base frame [part no. 2] using the attachment
bracket and by means of 2 M6x50 screws and 2
M6x35 screws (each with washers and nuts).
Put the upper tow bar part [part no. 5] on to the
lower part and connect the two parts by putting the
self-locking screw M6x35 into the square opening and
screw it tight with its washer and nut.
Step 1
Attaching the spoke
reflectors
Step 2
Fitting the wheels
IMPORTANT:
Step 3
Attaching the reflectors
Step 4
Attaching the lower tow
bar part
Step 5
Attaching the upper tow
bar part
27.11.15 15:01