Operation - Batavia 7062072 Mode D'emploi

•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Please Note: Ensure that the door viewer is mounted approximately
at eye level of the user. This ensures an optimal image on the LCD
screen.

OPERATION

•
•
062072 Doorviewer Ma 1412-01.indb 11
If the hole is not big enough (14mm diameter) or if there is no
door viewer at all in the door, then drill a hole of 14mm diameter
through the door in a convenient location (at eye level).
The door viewer is suitable for doors with a thickness of min
38mm to max 64mm.
Unscrew the door viewer sleeve (4) from the door viewer (1).
Replace the old door viewer with the new door viewer (1) on the
outside of the door.
Place the large silicone ring (5) between the door and the door
viewer.
Make sure that the white arrow (2) on the door viewer is facing
up.
Open the cover (7) at the back of the monitor (8). Slide the cover
(7) down and open the cover.
Slide the door viewer sleeve (4) through the opening of the cover
(7).
Place the small silicone ring (6) on the door viewer sleeve (4).
Slide the cable (3) through the door viewer sleeve (4).
Screw the door viewer sleeve (4) tightly on the door viewer (1).
Tighten the door viewer sleeve (4) with a coin.
Connect the cable (3) to the monitor with the tab (10) down.
Using the tab (10) with the text "pull up" you can easily remove
the cable (3) from the monitor (8).
Insert the 3 AAA batteries. Observe the polarity.
Fix the monitor (8) on the cover (7) until it clicks into place. Slide
the monitor down so that it is properly attached on the cover.
Press the ON button (9) to see who is at the door.
The monitor will turn on for 15 seconds and automatically switch
off again.
English
11
23-03-15 11:07