Publicité
Figure 1
Positioning references
INSTRUCTIONS:
1. Center the protector plate on the stud by using positioning references (Figure 1) and
hammer it using the nailing prongs (Figure 2).
2. Installation of the protector plate on a floor plate (simple or double) or on a stud of an
adjacent wall, can be done by using the nailing prongs (Figure 3).
MADE IN CANADA
WARRANTY: Thomas & Betts sells this product with the understanding that the user will perform all necessary tests to determine the suitability of
this product for the user's intended application. Thomas & Betts warrants that this product will be free from defects in materials and workmanship
for a period of two (2) years following the date of purchase. Upon prompt notification of any warranted defect, Thomas & Betts will, at its option,
repair or replace the defective product. Misuse or unauthorized modification of the product voids all warranties.
Limitations and Exclusions: THE ABOVE WARRANTY IS THE SOLE WARRANTY CONCERNING THIS PRODUCT, AND IS IN LIEU OF ALL
OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE, WHICH ARE SPECIFICALLY DISCLAIMED. LIABILITY FOR BREACH OF THE ABOVE
WARRANTY IS LIMITED TO COST OF REPAIR OR REPLACEMENT OF THE PRODUCT AND UNDER NO CIRCUMSTANCES WILL
THOMAS & BETTS BE LIABLE FOR ANY INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES.
© 2012 Thomas & Betts. All rights reserved
Instruction sheet for
PROTECTOR PLATE
CI66-XL
Figure 2
Thomas & Betts Canada
Saint-Jean-sur-Richelieu, Québec
www.tnb.ca
Figure 3
CTA00784 C
Page 1 of 1
Publicité
