Publicité
TROUBLESHOOTING TABLE
Problem/error
The machine
will not start.
There is voltage
in the outlet,
but the drum does
not spin and the
appliance does
not work.
The appliance
stops heating
completely during
a programme.
A slight hitting noise
appears.
The door opens
during drying.
Unevenly dried
laundry.
Cause
• The main switch is not
switched on.
• There is no voltage in the
power outlet.
• Open the door.
• The condensate tank
is full.
• Perhaps the START
DELAY function was set.
• Programme was not
started in accordance
with the instructions.
• The dryer filter may be
clogged. As a result, the
temperature in the dryer
rises, which in turn causes
overheating, and therefore
heating is switched off.
• If the dryer is out of use
for a long period of time,
the support elements are
under stress at the same
point.
• Excessive load on the
door (too much laundry
in the drum).
• Laundry of varying
types and thickness, or
excessive amount of
laundry.
What to do?
• Check whether the main switch is on.
• Check the fuse.
• Check if the power cord plug is
correctly inserted into the power
outlet.
• Check if the door is closed properly.
• Empty the condensate tank
(see chapter »CLEANING AND
MAINTENANCE/Emptying the
condensate tank«).
• To cancel the start delay, press
START DELAY [startuitstel]
and hold for 3 seconds.
• Re-read the instructions for use.
• Clean the dryer filter (see CLEANING
AND MAINTENANCE/Cleaning
the dryer filter).
• Wait for the appliance to cool down,
and try running it again. If the dryer still
fails to start, call a service technician.
• The noise will subside without any
intervention.
• Reduce the amount of laundry.
• Make sure you have sorted the laundry
by type and thickness, and check that
you have added a suitable amount
of laundry to the drum, and that you
have selected a suitable programme
(see PROGRAMME TABLE).
English
•
55
Publicité
