Publicité
3
Installing the AM6162G5 Indoor amplifier
Method 1
TV SIGNAL DISTRIBUTION
1. Connect your UHF/VHF aerial downlead
(tipically via an aerial wall socket) to the
ANT socket on the amplifier.
2. Connect up the four TVs to the TV
socket on the AM6162G5
Method 2
TV/VCR/DTT
1. Connect your UHF aerial downlead to
the aerial input VCR & DTT receiver.
2. Connect an aerial fly-lead from the
aerial output on the DTT receiver to the
aerial UHF input of the AM6162G5.
3. Connect up two TVs to the TV socket on
the AM6162G5
Method 3
TV/VCR/DTT (digital Terrestrial
Television) DISTRIBUTION
1. Connect your UHF aerial downlead to
the aerial input on the DTT receiver
2. Connect an aerial fly-lead from the
aerial output on your DTT receiver to the
aerial input on your VCR recorder and its
output connect to the AM6162G5 UHF
input
3. Connect an aerial fly-lead from the
aerial output of VHF Modulator to the
antenna input of AM6162G5
4. Connect up four TVs to the TV socket
on the AM6162G5.
Once connected you can tune each
television
to
traditional
channels, a channel VCR viewing and a
channel for DTT viewing
Some DTT/SAT receivers do not have a
RF output channel. Then use the external
modulator (MV7125, see fig 3)
If you are receiving poor DTT reception
then connect the AM6162G5 before
your DTT receiver to help boost the
signal strenght. In most cases, poor DTT
reception can only be cured by acquiring
a suitable aerial (see troubleshooting) or
waiting until DTT coverage improves in
your area.
EN
terrestrial
Publicité
