Publicité
PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
1 Ground Screw (#8)
3 Wire Connectors (#12)
INSTALLATION INSTRUCTIONS:
1. Thread Nipple (#10) into the collar loop (#6) until snug.
2. Thread other end of Nipple with Loop attached into single bar (#11) until snug.
3. Place Lock Washer (#16) over end of Nipple protruding through crossbar and
thread Hex Nut (#15) onto nipple until tight.
4. Take the crossbar assembly and mount to ceiling outlet box (#13) with outlet box
screws (#9). Tighten screws securely with screwdriver.
5. By measuring determine correct number of links needed for proper hanging
height. Use a pair of pliers to open one end link of the chain and discard un-
wanted chain. (Don't disregard the Quick Link linked at the end of Chain.)
6. Slip Canopy (#3) and Thread ring (#7) through over the Chain (#2), then connect
the other end of Chain (#2) to Loop (#5) by using Quick Link (#14).
7. Lace the fixture's wires through the chain links and pull until taut. Feed the
fixture wires through the Thread ring, Canopy, chain and Nipple and pull until
taut.
8. Connect the ribbed wire from the fixture to the Neutral wire from the outlet box
(#13) and the smooth wire from the fixture to the hot wire from the outlet box
(#13). Cover the two wire connections using the two provided wire connectors
(#12). Wrap the two wire connections with electrical tape for a more secure
connection. If your outlet box has a ground wire (green or bare copper), connect
fixture's ground wire to it using the wire connector (#12). Otherwise connect the
copper ground from the fixture to Ground screw (#8) on the single bar (#11). Note:
If you have electrical questions, consult your local electrical code for approved
grounding methods.
9. Tuck these wire connections neatly into the ceiling outlet box and then raise the
canopy all the way to the ceiling. Raise the Lock Collar and thread onto Ceiling
Loop protruding through Canopy.
10.
Installation is complete. Turn on the power at the circuit breaker or fuse box.
Turn the light switch on to activate the fixture.
Page 6
2 Outlet Box Screws (#9)
1 Hex nut (#15)
1 Nipple (#10)
1 Lock Washer (#16)
1 Single Bar (#11)
Publicité
