Publicité
en
Fault
Controls have reduced
luminosity.
Displays
do not illuminate.
Warning signal
sounds.
The alarm button is lit.
Fig. 2/2
38
Possible cause
When the appliance is
not used for some
time, the display on
the fascia switches
to energy saving
mode.
Power failure; the fuse
has been switched off;
the mains plug
has not been inserted
properly.
Fault – the freezer
compartment is too
warm!
Appliance is open.
Ventilation openings
have been covered.
Too much food was
placed in the freezer
compartment at once.
Remedial action
As soon as the appliance is again
used, e.g. the door is opened,
the display switches back to normal
illumination.
Connect mains plug. Check whether
the power is on, check the fuses.
To switch off the warning signal,
press the alarm button 2.
Close the appliance.
Ensure that there is adequate
ventilation.
Do not exceed max. freezing
capacity.
When the fault has been eliminated,
the alarm button goes out shortly
afterwards.
Publicité
