Publicité
AIR HYDRAULIC JACK 80/50T
EN
1.
Study, understand and follow all instructions before operating this jack.
2.
Do not exceed rated capacity.
3.
Use only on hard level surface.
4.
Do not move or transport the vehicle while on the jack.
5.
Lifting device only. Immediately after lifting, support the vehicle with support stands.
6.
Lift only on areas of the vehicle as specified by the vehicle manufacturer, and only centrally on the lifting
saddle.
7.
No person shall remain in, on, or get bodily under a load that is being jacked or is supported only by a
jack.
8.
Only original accessories and spare parts shall be used.
9.
No alterations shall be made to this jack.
10. Failure to follow these warnings may result in personal injury and/or property damage.
11. Maintenance and repair must always be carried out by qualified personnel.
a. Daily: Inspect jack for damages.
b. Monthly: Lubricate all mechanical parts with a few drops of oil.
12. Trouble shootings:
a. The jack does not lift to maximum position: refill with oil ISO VG15.
b. The load is dropping due to leaking pump valves or worn seals: Contact your distributor.
13. According to national legislation - minimum once a year though - the jack must be inspected by a
professional: damages, wear and tear, adjustment of the safety valve, hydraulic unit for leakages. Possible
faults and how to overcome them.
14. Disposal: Oil must be drained off and legally disposed of.
15. Make sure the Jack is working in the temperature condition -20ºC to 50ºC.
• The jack conforms the standard EN 1494:2000/A1:2008
• If the jack can not be lowered as wished, the car must be secured by jack stand against unintended
lowering. Get a new jack, with which you can lift the car, so that the defect jack can be removed. If you are
unsure, please ask for professional help.
• It is necessary that the operator can watch the lifting device and the load during all movements.
• It is not allowed to work under the raised load until it is secured by suitable means.
• Need to check the state of the markings and that the markings remain as the initial one.
3
Publicité
