Publicité
- Turn the unit off and unplug the power cord when the appliance is not in use, before clea-
ning and when changing the location of the appliance.
- Do not use the appliance where it can fall or push into the water. Never reach for the appli-
ance that has fallen into the water. Switch off the mains fuse immediately and unplug the
mains plug.
- Check regularly, but most defi nitely before every use, the mains cable and mains plug for damage.
- If any damage is visible, then further use of the unit must not be made.
- The appliance is not to be used by children or persons with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been supervision
or instruction.
- Disconnect the appliance from the mains before performing any maintenance work, by plug-
ging the plug or disconnecting the electrical system.
- If any damage and/or reduced functioning occurs, switch off and do not manipulate the unit.
- If, in such as event, a repair is necessary, contact an authorised by the manufacturer custo-
mer service point.
- Always take note of the general safety rules when using electrical equipment.
Maintenance/cleaning notes
- Before carrying out any cleaning or maintenance work, remove the plug or switch off the
electrical equipment!
- Clean the surface of the housing and the guard with a dry cleaning cloth and a damp brush.
- Do not use petrol or any similar light fl ammable cleaning material.
Storage
- If the fan is not to be used for some time, then store it in a dry room.
- In addition, you could put a cover on your unit to protect it from dust or dirt deposits.
Disposal
- Remove mains plug.
- Cut through the mains cable at the plug.
- Dispose of the unit in a proper manner.
Help with faults
Problem
The heater does not work.
If the above information does not fi x the problem, unplug the heater by removing the plug
from the wall socket.
In the case of a damage or breakdown, please leave the heater with a qualifi ed electrician
to fi x the problem.
If the power cord on the unit is dam aged it may only be re placed by a repair facility autho-
rised by the man u fac tur er. Re place ment of the pow er cord re quires spe cial tools.
Attention: Any repairs including replacing the halogen heating lamp should only be
carried out by a qualifi ed electrician or by a recommended service center!
Suggestions for rectifi cation
1-
Check main and ancillary fuses. It should be
an non-fast acting fuse dimensioned for the
maximum power of your heater.
2-
Check heater for correct connection to the
power socket.
3-
Check the switch settings (On/Off) at the
heater.
EN
11
Publicité
