Armacost Lighting 412923 Mode D'emploi

White 3W LED Landscape Light
with Spike
Beautifully highlight small trees, shrubs, walls,
structures, and pathways while providing enhanced
safety and security of your property. These outdoor
lights are easy to install and low-voltage safe.
Rugged cast aluminum construction with a
■
36 in. power wire lead
All stainless steel hardware with a durable
■
black powder coat paint finish
IP67 wet location rated, water-resistant
■
housing and seals; maintenance-free operation
No bulbs to change, rated for 40,000 hours
■
or 13 years if left on for eight hours a day
Approximately 30° beam angle
■
Ambient air operating temperature range is -4°F (-20°C)
■
to 140°F (60°C)
Operates off either 12-volt or 24-volt AC or DC power – this
model can be used with existing low-voltage landscape
lighting transformers that have 12-volt or 24-volt AC output.
Provides output of approximately 200 lumens.
INSTALLATION
Not suitable for underwater applications
■
Do not stare directly into the light when illuminated
■
Basic wiring skills such as stripping, splicing, extending, and
■
connecting wires are required
Power supplies, color controllers, wire, and connectors sold separately
■
1 2
Adjust angle
Determine your power supply requirement
Add together the individual wattages of all the LED light fixtures used
in your design. Always choose a power supply rated greater than your
needs. The number of lights installed is limited only by the watts output
rating of the power supply. Each light uses 3 watts.
Connect
to power
Power supply location, voltage drop
Voltage drop is the gradual decrease in voltage that occurs from your power supply to your LED lighting.
The shorter the wire leads between the power supply and the LED lighting, the brighter and more consistent
the lighting will be. Do not coil excess wire.
It's best to locate the power supply as close to the lighting as possible to lessen the effect of voltage drop. Always
use an appropriate enclosure to protect the power supply if not rated for wet location use.
Test your LED lighting prior to final installation.
On large installations with multiple lights, if voltage drop appears to be an issue, use thicker, heavier gauge wires
or power your system from both ends (see loop back configuration).
Layout options that will reduce voltage drop and promote more uniform light output
Loop Back
L
L L
POWER
POWER
L
L
L
Be sure to observe cable polarity in all applications.
Normal recommended wire is 12 to 18 AWG. All cables must be rated for underground use. To determine what wire
size will work best in your design, visit armacostlighting.com/voltagedrop for an easy-to-use online voltage drop
calculator.
Typical connections
All wire splice connections should be made waterproof using outdoor, wet location rated connectors such as
silicone-filled wire nuts, crimp butt-splice connectors that use sealants, or heat shrink tubing.
Always maintain polarity: (+) to (+) and (–) to (–) for 2-wire white lighting.
POWER
SUPPLY
2-wire white LED connection series hook-up
Three-year limited warranty
Improper installation, abuse, or failure to use this product for its
intended purpose will void warranty. This warranty only applies
when all components, including LED power supplies, have been
provided by or approved for use by Armacost Lighting. The
warranty does not cover labor or any other costs or expense to
remove or install any defective, repaired, or replaced products.
Center Feed Array
L
POWER
L L L L L
L L
WHITE LANDSCAPE LIGHTS
armacostlighting.com
© 2023 Armacost Lighting. All rights reserved.
L L L
L L
230801