Publicité
01.
Front Guard
02.
Spinner
03.
Blade
04.
Guard mounting nut
05.
Rear guard
06.
Motor shaft
07.
Oscillating knob
08.
Switch button
09.
Switch housing fixing bolt
10.
Power supply cord
ASSEMBLY
1. Place Base A on Base B to form X-base (11).
2. Place lower pipe (13) with pipe support on X-base (11) fixed them together with four
screws provided.
3. Loosen and remove the pipe connector(16) from lower pipe (13). Slide plastic base orna-
ment over lower pipe (13) onto the base (11). Extend upper pipe (14) and slide pipe connec-
tor (16) over upper pipe (14) into lower (outer) pipe (13) and tighten.
4. Attach the motor with switch housing onto the upper pipe (14). Ensure the switch housing
is pushed fully onto the upper pipe (14) and secured with the screw provided.
5. Loosen guard mounting nut (4) from the motor housing.
6. Position rear guard (5) firmly to motor housing and then fasten by turning guard mounting
nut (4) clockwise tightly.
7. Remove and discard the PVC sleeve on the motor shaft (6).
8. Push the blade along motor shaft (6) and fasten it firmly with spinner (2) by turning counter
clockwise.
9. Hang the front guard (1) to rear guard (5) with the position fixer (18) provided at the rim of
guard and then fix together with screws (20) and clips (19) provided
NAME OF PARTS
11.
Base
12.
Base stopper
13.
Lower pipe
14.
Upper pipe
15.
Pipe ornament
16.
Pipe connector
17.
Switch housing fixing nut
18.
Position fixer
19.
Fixing clip
20.
Fixing screx & nut
Publicité
