Rear Panel - Denon Professional DN-306X Guide D'utilisation

Rear Panel

1
2
1. AC Power Input: Use the included power cable to connect this input to a power outlet.
2. Fuse Cover: If the fuse is broken, use a screwdriver or other tool to lift this tab, and
replace the fuse with a fuse with the same rating. Using a fuse with an incorrect rating can
damage the unit and/or fuse.
3. Mic/Line Inputs: Connect microphones or line-level devices to these inputs with XLR or
1/4" (6.35 mm) cables.
4. Input Selector: Use these switches to set what type of audio source is connected to each
mic/line input: a microphone without phantom power (Mic), a microphone with +48V of
phantom power (Ph), or a line-level device (Line).
Note: Most dynamic microphones do not require phantom power, while most condenser
microphones do. Consult your microphone's documentation to find out whether it needs
phantom power.
5. Mic 1 Priority: Turn this knob to set how loud the volume level of all other inputs will be
when the Channel 1 mic/line input receives an incoming signal. When the knob is turned
to the leftmost position, a signal received by the Channel 1 mic/line input will not affect the
other input signals at all. Turning the knob from the leftmost position towards the right
position will gradually have the Channel 1 mic/line input volume have priority over all other
input signals. When the knob is turned to the rightmost position, a signal received by the
Channel 1 mic/line input will mute all other input signals entirely.
6. Line Out: Use standard XLR cables to connect these outputs to your loudspeakers or
amplifier system. Use the Master Level knob to control the level of these outputs.
4
6
4
3
5