Publicité
USE
Slide the connection plug into the opening. Plug the power cord into a
1.
socket.
Press the power button to turn the device on. The device heats up. The
2.
standard setting is maintained: heat setting 1 and timer 6 hours.
Press the on/off button if you want to disconnect the appliance. Then
3.
unplug the appliance.
Note: Since it is a warming blanket for two people, both the left side and the right side can be adjusted
individually.
TEMPERATURE
You can adjust the temperature using the decrease (-) and increase (+) buttons. There are 6 settings, with
1 being the coldest and 6 the warmest. The selected heat setting is shown on the display.
In case of long-term use, e.g. if the user falls asleep, it is recommended to set the device to setting 1.
Setting 6 is recommended for a fast heat.
TIMER
After 6 hours, the device will switch off automatically. This is a set safety measure. You can adjust this
time up to 6 hours using the timer button. Press the timer button multiple times to set the timer (2, 4,
6 hours). The time is visible on the display. You do not have to confirm this; the timer will be set if you
do not press any button for a few seconds. After this selected time has elapsed, the device switches off
automatically.
! Attention:
The device is equipped with overheating protection. This protection prevents the device from
·
overheating across its entire surface by automatically switching off the power in the event of a
malfunction. Please note that the device may not be used afterwards for safety reasons and must be
returned to your retailer.
Prolonged use on a high temperature setting may cause burns on a sensitive skin.
·
Check if the temperature is pleasant with the top of your hand. This zone is more sensitive than the
·
palm of the hand.
If you use the appliance for several hours at the highest setting, the appliance could overheat.
·
Spread out the electrical blanket evenly over your mattres, starting at the foot of your bed.
·
The electrical blanket cannot be folded, tucked in or laid around the mattress.
·
Now place the sheets on the bed, like you normally do. This way the electrical blanket is situated
·
between the mattres and the sheets.
Always make sure the electrical blanket is straight and doesn't get wrinkled up or gets folded during
·
use, especially when you have an adjustable bed or a mattres which consists of more than one part.
Make sure to check the blanket when you make up your bed, the electrical blanket can only be used
·
when it is laid out flat.
We recommend to turn on the electrical blanket 90 minutes before going to bed and to cover the
·
blanket with your quilt or with the covers, to prevent the heat from escaping.
Caution: not suited for use on water beds.
·
www.domo-elektro.be
35
DO642ED
Publicité
