Publicité
How to Assemble
Place Tap Stem through
1
hole in Lower Tank with a
Silicone Washer on each
side. Tighten the Magnetic
Nut on the inside. Test for
leaks.
Place the Lower Tank onto
2
the Base.
Place the Middle Ring onto
3
the Lower Tank.
Screw the Fluoride Filter
4
into the Cartridge
Connector and place it in
the Middle Ring.
Remove the nut and one
5
washer from the Ceramic
Pre-filter.
Leaving one washer
6
installed on the Ceramic
Pre-filter stem; place the
stem through the hole of
the Upper Tank. Place the
remaining washer on the
stem followed by the
Pre-filter Nut, then tighten
the nut. You should have a
Silicon Washer on each side
of the Upper Tank.
Condition your filtration
7
system (see next page).
8
Place Mineral Stones in the
Lower Tank.
English
Lid
Ceramic Pre-filter
Silicone Washer
Upper Tank
Silicone Washer
Pre-filter Nut
Cartridge Connector
Fluoride Filter
Middle Ring
Mineral Stones
Lower Tank
C
A
B
B
A – Tap Stem
B – Silicone Washers
C – Magnetic Nut
support.santevia.com
Base
Publicité
