Before Use - JB Systems High Q10 Mode D'emploi

BEFORE USE

Check if the following parts are included in the package of the main
unit:
Turntable platter
•
Slipmat
•
Counterweight
•
45-rpm adaptor
•
Headshell
•
Dust cover
•
Operating instructions
•
ASSEMBLY
Take the main unit out of the box and remove the packing.
•
Set the 45-rpm adaptor on the main unit.
•
Put the turntable on the central shaft.
•
Put the driving belt around the shaft.
•
Put the slipmat on the turntable.
•
Connect the headshell.
•
Connect the lead wires to the cartridge terminals. Connect
•
each lead wire to the terminal of the same color:
White (L+) = Left channel
Blue (L-) = Left channel
Red (R+) = Right channel
Green (R-) = Right channel
Install the cartridge to the headshell and tighten it with the
•
screws provided with the cartridge.
Insert the headshell into the front of the tone arm, turn the
•
locking nut clockwise with the headshell firmly held
horizontally.
Slide the counterweight onto the tone arm.
•
Set the anti-skating control knob to the same value as the sty-
•
lus pressure for replay purpose and set it between 0 and 1 for
scratch and back-cue application.
Install the dust cover on the main unit.
•
High Q10 4