Publicité
STEP 6
The interior Garnish Trim Ring must be trimmed to 昀椀t
your particular RV roof thickness.
measure the distance from the vehicle ceiling surface to
each corner of the MAXXFAN Control Plate.
Most RV roofs have some slope, so measuring each
corner is necessary.
6mm to 12.5mm longer than the dimensions measured
at each corner.
In Picture #6 below, the installation measures 90mm
from the ceiling (this is an example only) to the Control
Plate. After adding 12mm as in this example, using a
ruler, place a mark at 102mm on each corner of each
side of the Garnish Ring (refer to 6A, right).
marked, draw a line connecting all 102 mm marks on the
outside of the Garnish ring and trim accordingly (refer
to 6B, right).
THERMOSTAT
SENSOR
90mm
6
NOTE: DO NOT probe or tamper with the thermostat
sensor or IR sensor shown in illustration #6 above.
7
STEP 7
Complete the installation by placing any excess wiring
to the inside of the roof opening and sliding the Garnish
Ring into position.
Fasten in place by using the four
painted 昀氀at head screws provided.
CONGRATULATIONS!!!
You have successfully completed the
installation of your new MAXXFAN.
If you have questions, please visit
AIRXCEL.com or contract your
AIRXCEL / MAXXAIR Distributor.
To accomplish this,
The Garnish ring should be cut
CEILING
6A
Once
6B
MEASUREMENTS STATED IN STEP
6 ARE USED AS AN EXAMPLE FOR
ILLUSTRATION PURPOSES ONLY
FOR REMOTE CONTROL MODELS:
to the Operating Instructions for use and testing of
your remote control.
included, follow instructions, aim remote at the ceiling
unit and test your fan.
with a cradle for wall mount storage of the Handheld
Remote Control. Mount the cradle to your wall using
the (2) #6 screws provided. Remote may be placed
into the wall cradle for storage.
3
GARNISH RING
GARNISH RING
Install the two AAA batteries
The Remote Control comes
Refer
Publicité
