FONESTAR PDA-1408 Mode D'emploi page 7

Select the line with the IP and MAC address of the PDA-1408 loudspeaker processor and click APPLY.
Then click CONNECT and the STATUS indicator should turn green. Add the devices located on the
sidebar by dragging them into the gray area.
Double-click the desired device module to enter edit mode.
Note: To access the configuration of each device, it is necessary to set the device ID manually by right-
clicking on the device to be configured and selecting "Change Device ID".
2.- Star network mode: allows for the configuration and individual control of several PDA-1408 loudspeaker
processors connected to the same router. In this editing mode, the PC and the PDA-1408 loudspeaker
processor must be connected to the RJ-45 cable router.
In this editing mode, the system automatically detects the PDA-1408 speaker processor connected to the
network for configuration and control.
- 7 -
EN