Fan Assembly; "On/Off" Button - Lorell 49251 Manuel D'utilisation

•

FAN ASSEMBLY

1. Align the column with the groove on the base and fix them together using a
right-angle bolt (see Fig. 4)
2. Place the head unit on the column and tighten the screw in alignment with
the groove on the internal pole (see Fig. 1)
3. Remove the spinner on the head unit by turning it clockwise. Then remove
the plastic nut by turning it counterclockwise. Place the rear guard to the
head unit (see Fig. 1)
4. Screw the lock nut of grill clockwise, and in the meantime, fix the rear grill
(see Fig. 3)
5. Pull the blade to rotate after installing, so as to ensure that the blade can be
normally rotated (see Fig. 3)
6. Lock nut of blade anticlockwise, and then install the front fan cover (see Fig. 3)
7. Align screw holes on the outer ring of both the front and rear guards, with the positioning clip aligned as
illustrated. Press down all the buckles to fasten the front guard with the rear guard. At the screw holes, tighten
the separated screw and nut (see Fig. 2)
Considerate Hint:
If you can't find the internal pole, it slides inside the external pole, you can pull it out from the external pole.
INSTRUCTIONS FOR USE
•
Control panel (see Fig. 5)
On the control panel, there are three buttons and six indicators.

1. "ON/OFF" BUTTON

The key is for switching on the fan. The fan will start at low speed.
2. "SPEED" BUTTON
After the fan has started, this button serves as a speed selector in the sequence from
"low - medium - high - low" when this button is being pressed repeated or continuously.
3. "TIMER" BUTTON
To set the timer, press this button repeatedly or continuously. The timer can be set
from one hour to seven hours. Do not press the timers button if the fan is required to
operate continuously and in such state, the timer's LED does not light up.
•
Instructions for display of body
LLR49251_UserManual.indd 5
Speed Display Timer Display
5
Base Installation
Fig. 4
Fig. 5
10/26/18 3:17 PM