Publicité
Important: Read these instructions before using the equipment!
GB
Safety
- Read this user manual and keep it in a safe place. Use this product exclusively in the manner
indicated.
- This equipment must be assembled and used by adults.
-
The equipment complies with the EN-957 standard, classification H for use in the home. It must
not be used in a sports center or any other public, associative or rented space.
-
For totally safe use, a stable, level surface is required. Protect your floor covering with a mat.
Do not use the equipment in damp areas (swimming pool, sauna, etc.).
-
Do not allow children to play with this equipment. CARE declines all responsibility for any
injuries they may incur. Do not allow children close to this equipment when you are training.
-
CARE declines all responsibility if technical modifications are made to any of its products by the
user.
-
Maximum weight of user: 110 kg.
-
Before you start training, it is essential that you consult your doctor to determine the intensity
level of the program you use.
-
Excessive or badly programmed training can damage your health.
-
Keep your back straight when exercising.
-
It is strongly recommended that your wear suitable clothing and footwear.
-
For adjustable parts, bear the maximum positions in mind.
Maintenance
-
Regularly check that elements fastened with nuts and bolts are correctly tightened.
-
To maintain the level of safety, the equipment must be regularly checked. It is vital that any faulty
parts are replaced and that it is not used until completely repaired. Remember regularly to grease
moving parts.
As sweat is very corrosive, do not allow it to come into contact with the enameled or chromed
-
parts of the equipment, particularly the computer. Immediately wipe the equipment after training.
The enameled parts can be cleaned using a damp sponge. All aggressive or corrosive products
should be avoided.
RUNNING BELT ADJUSTMENT & LUBRICATION
Running Belt Adjustment:
After a long time of running, the belt will be stretched. You should turn the left and right bolts in the
rear roller clockwise direction at the same position until the running belt becomes tight.
The running belt is adjusted at the factory; it may become loose during transportation and from use.
Turn on the main power switch of treadmill and let the running belt run at the speed of 4~5 km/h
before adjusting, and then adjust the left and right bolts in the rear roller with the hexagon wrench. It
is better to adjust 1/2 circle at once. To make the running belt moves to the right, turn the left bolt
1/2 circle in the clockwise direction. To make the running belt moves to the left, turn the right bolt
1/2 circle in the clockwise direction.
Publicité
