Armacost Lighting 780002 Guide Rapide

ProLine Multi-Color + Multi-White LED Amplifier
Use LED amplifiers throughout larger lighting designs, white
■
or multicolor, with a single color controller to maintain color
consistency and synchronization of any color-changing effect.
Use in conjunction with a color controller and an auxiliary power
■
supply for large perimeter and array lighting applications.
Connect multiple LED amplifiers to a single controller to control
■
limitless lengths of lighting.
Connections and typical applications
In large area applications the low-voltage wire that runs from the controller to the LED lighting can sometimes be too long to carry adequate power
due to voltage drop. By integrating one or more LED amplifiers into the lighting installation, you can repeat the signal from the controller to add
lighting to other areas.
IMPORTANT: This device amplifies or repeats the controller signal, not the power. Each LED amplifier installed will require a separate power supply.
Output rating (watts) of the power supply connected to the LED amplifier is dependent on the power requirements of the LED lighting that is connected
to the LED amplifier. Follow your LED tape model instructions to determine power supply requirements.
Follow your LED tape model
instructions to determine
power supply requirements
ProLine Multi-Color + Multi-White LED Amplifier
Model no.: PA5 Connection: common anode
Input voltage: DC12V/24V Working temp.: -20~60°C
Output voltage: DC12V/24V Made in China
Output current: 6A/channel
Total output: Max 15A
Switching rate: 10Mbps
Controller signal input
Lighting connections from 2C up to 6C
Make sure to maintain polarity (CH1 to CH1, CH2 to CH2, etc.)
When a controller is wired directly to one or more LED amplifiers (not connected to LED lighting), the LED amplifiers and LED lighting can be located
up to one hundred feet from the actual color controller. This can often solve voltage drop issues and may also help with certain installation needs.
When a controller is direct wired to a LED amplifier, the cable will be transmitting only data, so a thick cable is not needed.
Perimeter Lighting Application
Color
Controller
Power
Supply
120V AC
Input
Tape light length limitation is based
on your model of LED lighting
Safety protection
The amplifier has a function to prevent it from being damaged by mis-
wiring, output short circuit, overloading, or overheating. It will automatically
shut down under these extreme conditions until safe operating conditions
are restored. To avoid shutdowns, make sure the installed LED lighting
is compatible with constant voltage driving, is in the rated range of the
amplifier, and the cables are well connected and insulated. Also, install
the amplifier with proper ventilation and heat dissipation in mind.
SPECIFICATIONS
Working voltage .................DC12V/24V
Rated output current ... 5x6A (15A max)
Output mode ...... PWM constant voltage
Overload protection ........................Yes
Power supply input
Item 780002
Connect inline
Output to lighting
to control limitless
lengths of LED lighting
Cable can be thin, i.e. 22AWG
LED
Amplifier
Overheat protection ........................Yes
Working temperature ........... -4°~140°F
.......................................(-20°~60°C)
Dimensions ...............4.5 x 1.9 x 1.1 in.
..............................(115 x 48 x 27mm)
Professional-grade, high-capacity unit is rated for up to 180 watts
■
of 12-volt LED tape lighting or 360 watts of 24-volt LED lighting.
No minimum load is required.
Suitable for indoor or outdoor use when unit is installed in a proper
■
wet location enclosure.
Uses proprietary high speed optocouplers that keep LED lighting
■
colors and effects in synchronization regardless of the number of
LED amplifiers installed.
120V AC
Input
Power Power
Supply Supply
Color
LED
Amplifier
Controller
Large Array
Remote
Installation
Application
120V AC
Input
Power
Supply
Power
Supply
Color
Controller
When a controller
is direct wired to
the LED amplifier,
the controller
can be up to one
hundred feet from
the LED amplifier
and the lighting
Manufactured in China
Item # 780002
Power
Supply
LED
Amplifier
LED LED
Amplifier Amplifier
Power Power
Supply Supply
Power
Supply
LED
Amplifier
Power
Supply
LED
Amplifier
Power
Supply
LED
Amplifier
armacostlighting.com
© 2022 Armacost Lighting. All rights reserved.
221101