Publicité
Line in setup
This method is recommended for systems with no LFE/
subwoofer output jack, such as 2-channel systems.
1. Turn off the power of the device (such as a pre-
amplifier) you intend to connect to the subwoofer.
2. Connect standard RCA cables from the left and
right inputs of the subwoofer to the appropriate
output of the device, usually a left and right post-
volume pre-out.
Do not use a tape-out or record-out as
NOTE:
these will not track the volume control.
3. Adjust the volume, lowpass, and phase controls on
the subwoofer as needed. You can start at 80Hz
and 0 degrees and adjust from there.
Plug in the power cable and turn on the subwoofer
4
1. Plug the power cable into the subwoofer, then
into a power outlet.
2. Turn on the subwoofer by switching the Main
On/Off Switch. See the next page for more
information.
Setup is now complete!
5
Watch TV or listen to music and adjust the subwoofer settings to your preferences. See the next page for a
diagram of the subwoofer back panel.
For support, FAQs, and more information about the subwoofer, visit polkaudio.com/SignatureElite.
5
Publicité
