Publicité
DISTILLER W-4L
Please read before use and fi le for future use
1. Before Use
Unpack the water distiller and check all the components are present and undamaged. The box should
contain:
1. Distiller
2. Storage bottle
3. Bottle cap + Discharge cap
4. Nozzle
5. Main power cord
6. Instruction manual
2. Set up
1. Remove storage bottle from inside the water distiller.
2. Fill tank inside the machine body up to the highest water level line. Be very careful not to overfi ll
the tank (time needed to distill water can be reduced by using already boiled water).
3. Place top cover onto machine body making sure the silicone seal is correctly in place around the
entire rim. Check to make sure the unit is on a stable surface. Then connect power wire from the
top cover into the machine body.
4. Set up storage bottle as per diagram I. Connect power cord to power outlet.
5. Press the "Starting button". The fan will come on automatically and the tank will begin to heat,
thus starting the distilling process.
6. Water will begin to drip into the storage bottle after approximately 30 minutes. It will take
approximately 4 hours to distill 4 litres of water. The unit will automatically shut down when the
cycle has fi nished.
Please note: The unit must be allowed to cool down before starting another distilling cycle. (This
will prevent injuries from scalding water and prolong the life of the Distiller).
7. Do not use the fi rst bottle of distilled water. It will take one distilling cycle for the unit to 'self-clean'.
Wipe out tank and rinse/discard water in storage bottle. Distiller is now ready to create distilled water.
Please note:
– Use unit in a dry, well ventilated area.
– Keep the body of the unit dry - only fi ll with water using a jug.
– "Starting button" will begin distilling cycle and unit will automatically turn itself o when cycle is
fi nished. To stop unit mid-cycle turn o the power switch.
– Leave power cord unconnected when unit is not in use.
– Do not immerse any part of the unit in water.
– Do not remove cover whilst unit is mid-cycle. Wait until unit has cooled down before removing top.
3. Cleaning
Rinse and wipe out tank every day using clean water.
Calcifi cation and scale will build up on bottom of the tank and should be removed every two weeks.
Use following instructions:
1. Pour in enough hot water to cover scale in the tank.
2. Pour 1-4 teaspoons of sodium bicarbonate cleaning powder into the tank depending
on the amount of scale.
3. Leave lid o unit and start up a cycle by pressing the "Starting button".
4. Let cycle run for 30 minutes, pour out water and wash the inside of tank with clean water.
5. If scale is not completely removed repeat the process.
6. Replace carbon bag in nozzle every 3 months.
4
en
Power wire of the top cover
Main power cord
Socket of the machine body
Machine body
Top cover
Machine body
Starting button
Indicator light
Top cover
Main power cord
Fuse holder (2X10A)
Filter
Discharge cap
Storage Bottle
Main power cord
Interrupteur
Filter
5
Publicité
