Atlantic Colorfalls CF12 Manuel D'utilisation page 2

Introduction
Thank you for choosing Atlantic's Colorfalls. The Colorfalls are designed for use in
Pond-free and fountain applications and install easily into most retaining walls.
Colorfalls feature low energy LED lights, an extra-long reinforced weir, and an
interior baffling system that produces a single, lighted water sheer.
Prior to Operation and Installation
Caution:
• DO NOT operate this product under any condition other than those
for which it is specified. Failure to observe these precautions can lead
to electrical shock, product failure, or other problems.
• Follow all aspects of electrical codes when installing the Colorfalls.
• To reduce the risk of electrical shock, connect only to a 110 volt
receptacle protected by a ground fault circuit interrupter (GFCI).
• Colorfalls are designed for use in Pond-free and fountain applications.
Colorfalls are not intended for use in water gardens or any pond with
plant or aquatic life.
The Colorfalls must be accessible for service and maintenance. Installing the
Colorfalls so that the entire body is removable is highly recommended. Do not
glue the cap stones above the Colorfalls or permanently mortar the Colorfalls
in place.
The Colorfalls can support 40 lbs. per linear foot (e.g. a 24" Colorfalls can support
80 lbs.). If the weight on the weir exceeds that amount, you will need to provide a
lintel support for the added weight. This support should still make contact with the
weir to prevent it from shifting.
See the chart below for the recommended placement of the Colorfalls above the basin or pool.
If the placement of the Colorfalls exceeds the recommended height, water loss will increase
significantly due to splash and wind drift.
Colorfalls
CF12
CF24
CF36
2
Maximum Falls
Height Above Basin
18" - 24"
24" - 30"
30" - 36"
Flow Rate
1000 GPH
2000 GPH
3000 GPH