Publicité
Operating Instructions
12 Port CAT 6A Patch Panel
Item no: 2498314
1 Intended use
The product is intended for use as an RJ45 patch panel.
The product is intended for indoor use only. Do not use it outdoors.
Contact with moisture must be avoided under all circumstances.
If you use the product for purposes other than those described, the product may be dam-
aged.
Improper use can result in short circuits, fires, or other hazards.
The product complies with the statutory national and European requirements.
For safety and approval purposes, you must not rebuild and/or modify the product.
Read the operating instructions carefully and store them in a safe place. Make this product
available to third parties only together with the operating instructions.
All company names and product names are trademarks of their respective owners. All rights
reserved.
2 Delivery contents
■
Product
■
Operating instructions
3 Operating Instructions for download
Use the link
www.conrad.com/downloads
complete operating instructions (or new/current versions if available). Follow the instructions
on the web page.
4 Description of symbols
The symbol warns of hazards that can lead to personal injury.
5 Safety instructions
Read the operating instructions carefully and especially observe the safety
information. If you do not follow the safety instructions and information on
proper handling, we assume no liability for any resulting personal injury or
damage to property. Such cases will invalidate the warranty/guarantee.
5.1 General
■
The product is not a toy. Keep it out of the reach of children and pets.
■
Do not leave packaging material lying around carelessly. This may become dangerous
playing material for children.
■
If you have questions which remain unanswered by this information product, contact our
technical support service or other technical personnel.
■
Maintenance, modifications and repairs must only be completed by a technician or an
authorised repair centre.
5.2 Handling
■
Handle the product carefully. Jolts, impacts or a fall even from a low height can damage
the product.
5.3 Operating environment
■
Do not place the product under any mechanical stress.
■
Protect the appliance from extreme temperatures, strong jolts, flammable gases, steam
and solvents.
■
Protect the product from high humidity and moisture.
■
Protect the product from direct sunlight.
■
Do not switch the product on after it has been taken from a cold to a warm environment.
The condensation that forms might destroy the product. Allow the product to reach room
temperature before you use it.
5.4 Operation
■
Consult an expert when in doubt about the operation, safety or connection of the
product.
■
If it is no longer possible to operate the product safely, take it out of operation and pro-
tect it from any accidental use. DO NOT attempt to repair the product yourself. Safe op-
eration can no longer be guaranteed if the product:
– is visibly damaged,
– is no longer working properly,
– has been stored for extended periods in poor ambient conditions or
– has been subjected to any serious transport-related stresses.
3
(alternatively scan the QR code) to download the
5.5 Connected devices
■
Also observe the safety and operating instructions of any other devices which are con-
nected to the product.
6 Connection and installation
Important:
– In case of doubt, do not perform installation yourself; leave it to a professional.
– For cabling use either the colour coding according to T568A or T568B (in Europe
T568A is usually used).
– Do not mix the two colour codes on your network, or otherwise the network connec-
tions may not work.
– For information about the Pin assignments and coding information, refer to section:
assignments [} 3]
7 Pin assignments
Pin
1
2
3
4
5
6
7
8
8 Cleaning and care
Important:
– Do not use aggressive cleaning agents, rubbing alcohol or other chemical solutions.
They damage the housing and can cause the product to malfunction.
– Do not immerse the product in water.
1. Clean the product with a dry, fibre-free cloth.
9 Disposal
This symbol must appear on any electrical and electronic equipment placed on
the EU market. This symbol indicates that this device should not be disposed of
as unsorted municipal waste at the end of its service life.
Owners of WEEE (Waste from Electrical and Electronic Equipment) shall dispose
of it separately from unsorted municipal waste. Spent batteries and accumulators,
which are not enclosed by the WEEE, as well as lamps that can be removed from
the WEEE in a non-destructive manner, must be removed by end users from the
WEEE in a non-destructive manner before it is handed over to a collection point.
Distributors of electrical and electronic equipment are legally obliged to provide free take-
back of waste. Conrad provides the following return options free of charge (more details on
our website):
■
in our Conrad offices
■
at the Conrad collection points
■
at the collection points of public waste management authorities or the collection points
set up by manufacturers or distributors within the meaning of the ElektroG
End users are responsible for deleting personal data from the WEEE to be disposed of.
It should be noted that different obligations about the return or recycling of WEEE may apply
in countries outside of Germany.
10 Technical data
Contact resistance.......................... max. 100 mΩ
Insulation resistance....................... min. 1000 mΩ, 500 V/DC
Dielectric strength........................... 750 V/AC RMS, 60 Hz, 1 min
Transmission rate........................... 10 Gbit/s
Ports ............................................... 12 x RJ45 (fully shielded)
Cable Ø .......................................... 5.0 – 8.5 mm (outer)
LSA terminal code .......................... T568A/B
Material........................................... SPCC, thickness: 1.5 mm
Wire Ø ............................................ 1/0.4 -1/0.65 mm (AWG 26/1 -22/1)
Standards ....................................... ISO/IEC 11801:2002 Class EA
T568A
T568B
white/green
white/orange
green
orange
white/orange
white/green
blue
white/blue
white/blue
orange
green
white/brown
white/brown
brown
brown
7/0.20 -7/0.16 mm (AWG 24/7 -26/7)
ISO / IEC EN 50173 Class EA
EIA / TIA 568-C Cat.6A
IEC 60603-7-5
Pin
blue
Publicité
