Publicité
Warning! Do not transport the device when it is hot. This can cause serious burns. To move the device, grasp it by the handle.
Power supply connection
Ensure that the operating mode switch is in the off - 0 position. Plug the heater into a mains socket.
Using the heater
On the control panel (II), set the thermostat knob to the position marked "MAX" so that the device operates at full power.
To start the device, set the operating mode switch to one of the three modes:
mode marked with a fan symbol: fan operation, without heater element turned on,
half-heater mode: operation of the heating element at half the heating capacity,
mode marked with a heater symbol: operation of the heating element at full heating power.
When the set temperature is reached, the heating element will stop working. Once the temperature is lowered, the heater will
again, on its own, activate the heating element. The heater switches the heating element on and off automatically to maintain the
set heater temperature. The heater does not have ambient temperature sensors and is not able to automatically change the airfl ow
temperature when the room temperature changes.
Switching off the heater
Caution! Before switching off the heating element, set the thermostat knob to the position marked "MAX" and switch the unit to fan
mode, leaving it for about two minutes, until the heating element has cooled down. Then switch off the unit by setting the operating
mode switch to the off - 0 position. Disconnect the device from the power supply and proceed with maintenance.
Maintenance and storage
Warning! Before starting any maintenance work, make sure that the device is disconnected from the power supply socket and is
completely cooled down. Clean the device housing with a cloth slightly dampened with water and dry it. Clean the area around the
heating element and the vent holes with a stream of compressed air of not more than 0.3 MPa. Never immerse the device in water
or any other liquid and do not clean it with a jet of water or any other liquid. Store the device disconnected from power supply. The
power cord must be unplugged from the power supply socket. The place of storage should be well ventilated and protected against
direct sunlight, moisture and precipitation, as well as against access by unauthorised persons, especially children. The heating
element is not intended to be replaced. If it is damaged, contact an authorised repair centre for replacement. It is forbidden to use
the heater with a damaged heating element.
TECHNICAL DATA
Parameter
Catalogue No.
Rated voltage
Rated frequency
Protection rating
Rated power
Output Range
Weight
Dimensions
Max. heating area
Airfl ow rate
O R I G I N A L
12
EN
Unit
YT-99690
[V~]
220 - 240
[Hz]
50
IP24
[W]
2000
[W]
20 / 1000 / 2000
[kg]
2,9
[mm]
191 x 169 x 287
[m2]
20
(m3/h)
420
I N S T R U C T I O N S
Value
YT-99693
220 - 240
50
IP24
3000
25 / 2000 / 3000
40 / 2500 / 5000
3,9
198 x 230 x 310
270 x 255 x 400
30
495
YT-99695
400 / 3~
50
IP24
5000
5,6
48
795
Publicité
