Prescolite LiteBox LBSE EM Instructions D'installation

LBSE/LBSES EM – LiteBox® Edge-Lit EM Extension Cable Accessory
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
Follow label information and instructions concerning Wet or Damp Locations, installation near combustible
materials, insulation, building materials, and proper lamping. Do not install in areas subject to combustible
vapors or gases. Before wiring to power supply and during servicing or relamping, turn off power at fuse or circuit
breaker. All servicing or relamping must be performed by qualified service personnel. Product must be
grounded to avoid potential electric shock or other potential hazard. Product must be mounted in
locations and at heights and in a manner consistent with its intended use, and in compliance with the
National Electrical Code and local codes. The use of accessory equipment not recommended by the
manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating
from product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes,
curtains, screens or the like to come into contact with the product or to block light from the product, as this may
cause an unsafe condition.
EM Extension cable accessory for use
with compatible Prescolite LiteBox
Edge-Lit LBSE and LBSES EM models
only (see spec sheet for complete
details).
Step 1
Make sure the power to the fixture is
turned off prior to installation.
Step 2
Install extension cable to mating
connectors as shown.
INSTALLATION INSTRUCTIONS
© 2022 HLI Solutions, Inc. All rights reserved.
currentlighting.com/Prescolite
Technical Support: 888.777.4832
Part No. ....93139872
Rev A
Page 1 of 2