Publicité
- USER MANUAL
Transfer
evo
1. Carton Contents
2. Connection
3. Setting up a Dante
4. Routing with the Dante
5. IP address modification
6. Transferevo software
7. Technical Specifications
8.Size
9. Connectors
1. Contents
- 1 Dante™ interface 4x4 Transfer
- 1 External power supply
- 1 Rack mounting
- 1 User manual
2. Connections
1. Input analog audio signals.
The analog audio signals enter the interface via the 2 orange connectors on the back
panel marked «INPUT» located on the top row of the unit. The input level is line level. Be
sure to check the cable diagram marked on the front panel.
2. Output analog audio signals.
The analog audio signals are output from the interface via the 2 black connectors on the
back panel marked «OUTPUT» located on the bottom row of the device. The output level is
line level. Please see the cable diagram marked on the front panel.
3. Audio network and power supply.
The connection to the Dante™ network is made via the RJ45 connector on the rear panel.
The Transfer requires 12 V DC operating voltage. Either an external transformer (incuded)
of at least 1000 mA or a PoE power supply must be used with the PoE splitter.
User' s manual - Transfer
network
TM
controller
TM
evo
evo
V1.0
08/2023
Page
10
10
11
11
12
13
15
16
17
10/20
Publicité
