Publicité
ASSEMBLY
All numbers in parenthesis () refer to the index number from the parts breakdown
1. Attached rail sections (13) to left and right posts
and lower cross member (19) using bolts (9),
washers (10), lock washers (11) and nuts (12).
5
11
10
9
2. Put the press frame in an upright position, attach
upper crossbeam (14) to left and right posts (5)
using bolts (1), washer (2), lock washer (3) and
nuts (4). Hook mounts should face down on upper
crossbeam.
14
12
19
13
4
3
5
3. Put the frame in an upright position, and attach
the upper crossbeam (14) and attached the
springs (15). Then attach eye hooks (17), using
nuts (20) to middle bolster (18). The attach
springs to middle bolster. (Middle Bolster will then
suspend between left and right frame posts.)
4. Carefully place 12 ton hydraulic bottle jack (16)
in between the middle bolster (18) and upper
crossbeam (14). Adjust the bolt (21) with washers
(22, 23) and nut (20) to the proper position once
jack has been installed.
2
1
6
14
15
17
18
20
Publicité
