Télécharger Imprimer la page

Princeton Tec SWITCH RGB Mode D'emploi page 2

Publicité

English
Figure 1 – Battery Installation
1
2
Figure 2 – Switch Operation
2a
Press 1x:
Red Low
Press 3x:
Off
2b
Press 1x:
IR
IR Low
Press 3x:
Off
Figure 3 – Programming Mode
5s hold from off:
Programming Mode
Figure 4 – ARC Rail Installation
Slide ARC Rail Adapter into ARC rail to desired position and secure in place with
center anti-slip lock screw.
DO NOT OVERTIGHTEN this screw.
1
Figure 5 – MOLLE Mount
Slide clip inside any strap position, pinch MOLLE strap to hook the lower end of
the metal clip onto the strap.
1
3
4
2s hold from red:
Press 2x:
Red High
White
Press 1x:
Off
Press 2x:
2s hold from IR:
IR
Color High
IR High
Press 1x:
Off
Press & cycle
5s hold on
to desired color:
desired color:
Save color
2
3
2
3
Figure 6 – M-LOK
®
Mount
Insert screw and T-nut into M-LOK
than the thickness of the
mounting surface. Slide mount on to M-LOK
2
1
SET GAP
Figure 7 – MICH Mount Installation
Back the screw out so the end of screw is flush with metal U-clip. Slide the
exposed U-clip over the bottom edge of your helmet with the metal clip on the
inside and the plastic base exposed on the outside of your Helmet. Holding Mount
firmly upward, tighten center slotted screw until it stops.
1
2
Figure 8 – Picatinny Rail Mount
Remove the center through screw from the side of the Picatinny base mount.
Slide Picatinny to desired position and insert side locking screw aligning with any
slot in Picatinny rail and tighten to clamp in place.
DO NOT OVERTIGHTEN this screw.
1
2
Figure 9 – (ABR) Above Rail Mount
A. If using MPLS ABR on a ballistic helmet, skip to step two. For use with
nonballistic helmets, begin by snapping off unneeded portion of ABR mount by
hand or with a pair of pliers, and discarding the smaller 'hook' portion
1a
B. Loosen or remove front rail screw, and slide ABR into desired position beneath
rail. Retighten front rail screw.
1b
2b
C. Select Charge MPLS mount and secure with included machine screws, gently
tightening with a Phillips screwdriver. Install Switch/Point onto mount.
1c
2c
1c
2c
®
mount. T-Nut "gap" must be slightly greater
®
rail and tighten with screwdriver.
3
4
3
3
2a
3b
4b
3c
3c

Publicité

loading