Publicité
UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
CONNECTIONS
1. CHANNEL 1 VOLUME LEVEL: Rotate to adjust the volume level of channel 1.
2. MIC / LINE SWITCH: Press to switch between line- and microphone input.
3. CHANNEL 1 INPUT: Combo jack input, suitable for both XLR and 6.3mm jack.
4. CHANNEL 2 VOLUME LEVEL: Rotate to adjust the volume level of channel 2.
5. RCA INPUT: RCA line signal input sockets.
6. CHANNEL 2 INPUT: Combo jack input, suitable for both XLR and 6.3mm jack.
7. LOW CUT / FLAT SWITCH: Switch to filter out the low frequencies (low cut) or keep the full frequency range (flat).
8. MASTER VOLUME LEVEL: Rotate to adjust the master volume level.
9. MIX OUTPUT: XLR output socket for mix output signal.
10. FUSE HOLDER: Screw-type fuse holder.
11. POWER SWITCH: Switch to turn the device ON or OFF.
12. POWER CONNECTOR: Socket for plugging in the supplied power cord.
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
3
Publicité
