Publicité
PRODUCT INSTALLATION
POWER SUPPLY
Please use the attached power, note that power voltage and frequency are the same as the marked voltage and
frequency of device when connecting power. Every device's power should be connected separately, so that de-
vice can be controlled individually.
DMX CONNECTION
Connection between laser lights and DMX must use the shied cable of diameter more than 0.5mm. Please use
the attached 3 pin XL plug/socket to connect the DMX output/input interface. The connection between socket
and cable as below (note the plug/socket's 3 pin number and position).
DMX-OUTPUT
XLR mounting-sockets (rear view)
2
When using standard DMX512 control signal, the last device's output interface must be connected to a DMX plug.
This plug is putting a 120 ohm resistance between "canon" plug's 2 pin and 3 pin. Showing as below pic. Sticking
this plug into the last device's signal output interface, it will avoid the interference during the process of signal
transmission.
OPERATION INSTRUCTIONS
2
1
FUNCTION
1
DMX IN / DMX OUT
2
POWER IN / POWER OUT
3
Fuse Holder
4
Keyboard
5
Display
6
Safety Cable
1 ∙ Shield
2 ∙ Shield (-)
1
3 ∙ Shield (+)
3
0.5
m
3
DESCRIPTION
Input/output DMX signal
110 - 240V~ power supply INPUT
For protection fuse - 5A / 250V~
For value selection & menus navigation
Display menu and values
Attachment for safety sling
DMX-INTPUT
XLR mounting-plugs (rear view)
2
1
3
4
5
P.14
PIN3
PIN2
6
Publicité
