Publicité
Liens rapides
INSTRUCTIONS
1800/1825 Series FOLDING
DOOR HARDWARE
FOR 1'/, OR 1% DOOR
PANELS TO 30 LBS.(13.6K|
If doors are not drilled tor pivots and guides, drill
vie-
dia.
holes 1%" deep, l'^ " from edges and centered detween door
faces. See C. (Rx 2 door set, determne fold direction and see
instniaions delow.i
TRACK - Fasten to LEVEL head jamd
from front edge. (For
2 door set. determine told direction and mount track with pivot
socket on desired fold side.i
JAMB BRACKET • Mount 1811 or 1861 JAMB BRACKET to
desired side jamb, resting on floor. Both mount the same, only
the adjusting feature differs. Pivot hole in bracket must be di¬
rectly below hole in Track Pivot Socket, see B. (If opening is
carpeted, see use of optional 1836 Carpet Riser.i
HINGES • (It not appliedl Lay doors GOOD SIDE down, flat and
even. Fasten 1805 Hinges 7" from top and 11" from bottom on
BACK Side. Optional center hinge is placed midway between
other hinges.
DOOR
nvOTS
- Tap fixed Pivot/Guide 1801 into holes In top
edge of doors, and adjustable pivot 1807 into proper hole in bot¬
tom edge of either left or right door depending upon location of
Jamb Bracket
AUGNER - (4 doors only) Fasten 1808 Aligner on BACK side of
doors. 6" from bottom, so fingers mesh when closed.
KNOB • Drill '/(,"(5mmi hole 36" from bottom of 2nd and 3rd
doors (See A) centered on doors.
MOUNT DOORS • Insert Top Pivot imo hole In Track Pivot Soc-
ei. and Guide into track groove. Set Bonom Pivot into hole in
Jamb Bracket Socket.
To minimize gap at top. lift doors to relieve pressure and turn
adjusting nut on bottom pivot
Close attention should be paid to the'4" clearance between doors
and side jambs, ff adjustmem is required, locsen prvot sucket in
track or reposition bonom pivot block in jamb bracket.
ADJUST SNAP CLOSE - SNUBBERS «12 (2 DRI and fi14
(40RI are setf-adjusting and are snapped into back. 1812 is in
back at apposite end tmm pivot socket. 1814 goes between door
pairs in center of openma For 1713 SNUBBER, close doors and
move Snubber against 1801 GUIDE (the sliding one). Open doors
and move Snubber
towards pivot socket end and tighten
Doors should "snap" closed.
1810
wiin 1811 only
1805
HINGE
1808
ALIGNERS
i4 DOORi
-FINISHED OPENING = 4 x Dr. Width -f 11/16'
{17.5mm)
4 DOOR INSTALLATION
1
•
•
1
m
— 1/
(1 5mm
(1 5mm)
(1 5mm)
lUii
1-
(6 5mm)
IIMl83SfD
L.E. JOHNSON PRODUCTS, INC. • 2100 STERLING AVE. • ELKHART, IN 46516 • 219-293-5664
Rev. 11/93
Publicité
