Publicité
Programming
Remote Control (Not Provided)
Up to 40 Security+ 2.0 remote controls can be programmed to the door operator. Older LiftMaster remote controls are NOT compatible, see the Accessories page of the original
installation manual for compatible accessories. To program additional accessories refer to the instructions provided with the accessory or visit LiftMaster.com. If your vehicle is
equipped with a Homelink
, you may require an external adapter depending on the make, model, and year of your vehicle. Visit www.homelink.com for additional information.
®
To Erase the Memory
ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
1.
Press and hold the LEARN button on door operator until the LEARN LED goes out (approximately 6 seconds). All remote control and keyless entry codes are now erased.
Reprogram any accessory you wish to use.
ERASE ALL DEVICES (INCLUDING myQ
ENABLED ACCESSORIES)
®
1.
Press and hold the LEARN button on door operator until the learn LED goes out
(approximately 6 seconds).
2.
Immediately press and hold the LEARN button again until the learn LED goes out.
All codes are now erased.
Reprogram any accessory you wish to use.
ERASE THE Wi-Fi NETWORK FROM THE DOOR OPERATOR
Press and hold the black adjustment button until 3 beeps are heard (approximately
6 seconds).
Black Adjustment Button
LEARN
Button
4
Publicité
