Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Auto Sure-Float™
8.0
Operator Control Panel
h
g
m
a)
POWER ON/STANDBY BUTTON switches the Control Unit between On and Standby modes.
b)
POWER STANDBY MODE INDICATOR indicates AC power is present to the Control Unit.
c)
MODE SELECT BUTTON Press repeatedly to toggle through operating modes, Auto-Float/Static,
Auto-Alternating Low Pressure, Manual-Float/Static and Manual-Alternating Low Pressure.
d)
AUTO MODE INDICATOR (Sensor cord from M1001S/M1002S series mattress must be
connected to control unit.) Mattress will automatically inflate to optimal level based on information
received from active sensors in mattress. The indicator adjacent to the symbol will illuminate while
Auto mode is active.
Note: Connecting the mattress sensor cord while the unit is not in Auto mode will cause the
Control Unit to enter Auto mode immediately.
If the sensor cord from mattress becomes disconnected from control unit while in Auto mode, an
audible alarm will activate and the Auto mode indicator will flash.
e)
MANUAL MODE INDICATOR Mattress inflation level user-determined by Comfort Adjust
(−, +) setting. The indicator adjacent to the symbol will illuminate while Manual mode is active.
f)
FLOAT/STATIC MODE INDICATOR all cells within mattress will be uniformly inflated when the
indicator adjacent to the symbol is illuminated.
n
l
f
c
Figure 1
6
b
d
o
j
i
e
k
a
Publicité
Chapitres
Table des Matières
Dépannage
