Publicité
.Lt_
IMPORTANT:
The product is powered by electricity. ln order to avoid burns, fire and electric shock, please read the
instructions carefully. Failure to read, thoroughly understand, and follow all instructions can result in serious
persona! injury, damage to equipment, or voiding of factory warranty. Should you ever have any questions or
feel you require help please contact your place of purchase for assistance.
I
Instructions of Safety and Warnings
• Make sure that the mounting surface is strong enough to handle mounted product and equipment.
• DO NOT EXCEED MAXIMUM LISTED WEIGHT CAPACITY.
• Always use an assistant or a mechanical lifting device to safely lift and position heavy products.
• Tighten screws firmly, but do not over tighten. Over tightening can cause product damage that greatly
reduces the holding power.
• Keep a clear area and distance from moving parts when using the product.
• Use only as intended. Never stand, hang or climb on the product.
• This product is intended for indoor use only.
• Any attempts to reconstruct the construction or alterations of the given power unit and contrai box aren't
allowed.
• This product may contain small items that could be a choking hazard if swallowed. Keep children away
unless the product is intended for their use and all instructions and manuals are fully reviewed and
understood by them.
• Check that the product is secure and safe to use at regular intervals (at least every three months).
1
Other Cautions
Don't clean the product with water while the power is still connected.
Don't disassemble or replace components while the power is still connected.
Never operate the system with a damaged cord or plug.
Never operate the system if it's in moist environment or its electrical components have contact
with liquids.
If the contrai box makes unusual noise or smells, switch off the mains voltage immediately.
-
Disposai: The product with this mark indicates that this product shouldn't be disposed with other
household wastes throughout the EU. To prevent possible harm to the environment or human
health from uncontrolled waste disposai, recycle it responsibly to promote the sustainable reuse
of material resources. To return your used device, please use the local recycle service or contact
your point of purchase to withdraw the product.
8. Drilling to the Desktop
• Attaching the assembled desk frame to the desktop through the
mounting hales found on the Side Brackets and Crossbar as shown
in the illustration using Screws mand Screws ffi.
• Remove the film release liners from the Anti-Vibration Pad
attach them to the Crossbar. Ensure that the Anti-Vibration Pads are
centered in the middle of the seam between the Iwo table boards.
4)
• Then attach the Hook
as shown.
1
1
9. Connecting Cords
• Connect the Controller
Owith
the AC Adapter œand motor as shown.
0:,
• lnsert the Power Plug
into the AC Adapter.
Note: Do not plug into the power before the desk is fui/y assembled
0)
and
œ , ,
1
i , i r
1
0�
1
1
1
1
� :,
1
1
e
ELECTRIC SIT-STAND DESK
Instruction Manual
150-5003
10. Attaching the Controller
• Attach the Controller to the desktop using Screws
Œ).
12. Adjusting the Desk
• Turn over the desk with the help of another persan.
• If the floor isn't even, simply rotate the pad to adjust the level to make the desk stable.
Tip: Use a bubble level (not included) to check if the desktop is even.
t,;,,
,
CAUTION: At least two people are required when turning over
l.lj.
the des/<, or serious bodi/y injuries might occur.
11. Cable Management
• Run the cables through the Cable Clips mand
œ
attach the Cable Clips to the desktop with
Screws
to ensure clean and neat surface.
Publicité
