Publicité
Resources Required
9/16
•
" Socket Wrench
3/4
•
" Socket Wrench
FAILURE TO SUPPORT THE TRAILER ACCORDING
TO MANUFACTURER'S RECOMMENDATION
BEFORE INSTALLATION MAY RESULT IN SERIOUS
PERSONAL INJURY, VEHICLE DAMAGE OR VOIDING
OF THE COMPONENT WARRANTY.
Installation Instructions
1. Remove the tongue jack from the coupler. Position
the PowerTower™ (Fig.1G) on the coupler. Place the
tongue jack on the PowerTower (Fig.1G) and secure
both to the coupler using 3 nuts, bolts and washers each
(Fig.1H, 1I and 1J).
NOTE: If there is no tongue jack, attach the PowerTower
(Fig.1G) to the coupler on the front of the trailer using 3
nuts, bolts and washers each (Fig.1H, 1I and 1J).
NOTE: There are two PowerTower options available. The
standard option has an inside clearance of 22
jack, to accommodate manual tongue jacks, has an 18
inside clearance.
2. Attach the Stinger™ (Fig.1F) to the PowerTower
(Fig.1G) using the NoMotion™ pin and washers
(Fig. 1A, 1C and 1D). For safety, insert the cotter pin
(Fig.1B) through the hole at the end of the NoMotion pin
(Fig.1A) after tightening securely.
NOTE: The NoMotion pins are lockable with a customer-
supplied padlock having a
3. Attach the base (Fig.1E) to Stinger (Fig.1F) using the
NoMotion pin and washers (Fig.1A, 1C and 1D). For
safety, insert the cotter pin (Fig.1B) through the hole at the
end of the NoMotion pin (Fig.1C) after tightening securely.
NOTE: Attaching the Stinger in any orientation other than
rearward voids the warranty.
lippert.com
432-LIPPERT (432-547-7378)
1/2
". The mini
1/4
" or smaller hasp.
Jack-It
Installation and Owner's Manual
(For Aftermarket Application)
B
A
1/2
"
H
I
J
Fig.1
2
CCD-0001715
®
D
C
F
E
G
Rev: 07.19.23
Publicité
