Hinkley Atlantis Serie Instructions D'installation

Fixture Body
Silicone filled
Wire nut
Fixture Wire
HINKLEY 33000 Pin Oak Parkway
 Start Here
Glass and Bulb Installation
1. With a Phillips screw driver, remove flat head screw on the
Bulb
2. Remove the front plate.
3. Insert the bulb into the socket.
4. Slide the glass in the glass track at the back of the fixture.
5. Once the glass is in place, re-assemble the front plate and
Glass
Luminaire Mounting
Front
Screw
(For typical ground spike mounting)
Plate
1. To prevent electrical shock, disconnect the transformer
2. Run wire from luminaire through mounting hole in the top
3. Attach luminaire to ground spike by threading to mounting
4. Place spike in desired position and insert into ground until
5. Strip the two wire leads from the Luminaire and connect to
Note: Wire is to be protected by routing in close proximity to
such
maximum of 6 inches (15.2 cm) in order to connect to
main supply wire. The main supply wire must have its
length cut off within 6 inches (15.2 cm) from a building
structure, a luminaire or fitting.
Supply Wire
Avon Lake, OH 44012
Installation Instructions
Family: Atlantis | Item No.
15014 & 1518 & 1518CD -LED
underside of the fixture.
screw.
from the electrical supply before installation or service.
of the ground spike.
hole in spike and locking it in place.
the ange of spike is flush with g round.
the main supply wire using the provided silicone filled
wirenut. Silicone filled nuts are intended for one-time use.
Wire Nut Capacity -2 pcs 18 AWG + 2 pcs 12 AWG
the luminaire or fitting or next to a building structure
as a house or deck. Wiring should be buried a
(p)800.446.5539 / (f ) 440.653.5555 www.hinkley.com