Publicité
ADJUSTMENTS & USAGE GUIDE
CLEANING
The elliptical climber can be cleaned with a soft, clean, and damp cloth. Do not use abrasives or
solvents on plastic parts. Please wipe your perspiration off the elliptical climber after each use. Be
careful not to get excessive moisture on the meter display panel as this might cause an electrical
hazard or meter failure.
Please keep the elliptical climber, especially the computer, out of direct sunlight to prevent screen
damage.
Please inspect all assembly bolts and pedals on the machine for proper tightness every week.
STORAGE
Store the elliptical climber in a clean and dry environment away from children.
All manuals and user guides at all-guides.com
ADJUSTING THE TENSION OF THE ELLIPTICAL
CLIMBER
Adjust the tension of the elliptical climber by rotating the
Tension Control Knob (No. C06) clockwise to increase
the level of resistance. Rotate the Tension Control Knob
(No. C06) counter-clockwise to decrease the level of
resistance.
Tension levels are set at Level 1 being the lowest and
Level 8 being the highest.
ADJUSTING THE BALANCE OF THE ELLIPTICAL
CLIMBER
If you find that the climber is unbalanced and causes
excessive movement when in use, you can adjust the
elliptical climber balance. Use the Spanner (No. B19) to
loosen the Nut (No. D37). Adjust the Foot Pad (No. C23)
on the Front & Rear Stabilizers (No. A11 & A12) of each
side if you need. After adjusting, tighten and secure with
the Spanner (No. B19).
MOVING THE ELLIPTICAL CLIMBER
To move the elliptical climber, hold the Upright Post (No.
A02) and tilt it until the movable wheels located on the
Transportation Wheel (No. C24) of the Front Stabilizer
(No. A11) touch the ground. With the wheels on the
ground, you can transport it to the desired location with
ease.
16
Publicité
