Publicité
Screen-off function:
● Whether the equipment is on/in standby, press and hold the combination
button (mode button ＋ humidity adjustment button) to trigger the
screen-off function . And press any button to wake up the panel. The
function will be effective when pressing the corresponding button again.
7. Drainage
1. Use of water tank
◆ When the water tank is full, the water full indicator on the panel will blink
(the whole equipment will stop running) and the BUZZER Sound will ring
for ten times to remind users to empty the water.
◆ Hold the handles on both sides
of the water tank and genty remove
the water tank.
◆ Lift the cover of the water tank
and pour the water out.
Note: When the water tank is full, please empty the water. Before putting
the water tank back, please confirm that the float is working, and then
use both hands to put the water tank in place.
14
◆ Genty press the water tank cover
back.
◆ Place the water tank back in the
correct position and restart the
dehumidifier.
2. Drainage Methods
If you don't want to frequently empty the water tank, you can connect a
drainage pipe at the back of the equipment. There are two drainage
methods to choose from .
(1) Continuous drainage with water pump
◆ Step 1: Rotate the water plug at the
drainage outlet on the water tank.
◆ Step 2: Connect a hose with 5mm inner
diameter to the drainage outlet. (The
recommended drainage height should not
exceed 5m/16ft.)
Note: This method uses an automatic water pump, so there is no need
for users to set it up. When using this method, the bottom drainage outlet
must close.
15
Publicité
