Publicité
OPERATING
INSTRUCTIONS
NOTE: Please read the instructions carefully
before use.
INSTALLATION AND OPERATION
1. Installation of the Brush/Crevice Tool
Remove accessory from the storage port, connect to
the vacuum tube by pushing into place (See figure A1)
NOTE: Crevice tool accessory can be stretched out for
usage. (See figure A2)
2. Start/stop (See figure B)
Press the on-off switch to start the vacuum operation.
When the switch is pressed for the first time, the
machine starts and works at low speed.
When the switch is pressed again, the machine works
at high speed.
When the switch is pressed for the third time, the
machine stops.
WARNING: Please keep the air intake unobstructed,
otherwise it may cause motor overheating and may
damage the machine.
3. Debris Emptying Cleaning (See figure C1,C2)
Press the debris emptying button to open the dust cup.
Rotate the filter counter-clockwise to remove and rinse
in clean water when needed. To reinsert the filter, rotate
clockwise and lock filter element in place.
Warning: Do not use the vacuum without installing the
10
filter element. If the suction becomes decreased, it is
necessary to clean out the debris in the debris collection
container
4. Filter Cleaning
The filter is composed of the filter net cylinder and the
HEPA filter. Remove both and discard debris (see figure
D1). Both filters can be rinsed in clean water and air
dried. Replace HEPA filter inside Net cylinder filter, rotate
clockwise until locked. Locate three long slots on HEPA
filter and match those in the debris collection container.
Rotate clockwise to secure connection prior to using.
(See figure D2)
Note: In order to maintain excellent suction, it is
recommended to change HEPA every three months.
MAINTENANCE
WARNING: Remove the battery before carrying out any
servicing or maintenance.
Never use water or chemical cleaners to clean your
power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free of
dust. If you see some sparks flashing in the ventilation
slots, this is normal and will not damage your power
tool.
Operation instructions for the accessories
The brush is suitable for dust removal from inaccessible
20V Vacuum Cleaner
corners in the interior of the car, such as the bottom of
the seat, the side of the seat, the inside of the door, the
area around the driver's seat, the rear window, the trunk
of the car, etc.
The crevice tool can be used to clean most of the cracks
and corners of the car.
Precautions when using the machine
Cannot be used to absorb water.
Cannot be washed in water.
Check the hoses regularly and stop using if there is any
damage.
When cleaning or maintaining, remove the battery pack.
STORAGE
Clean the moulded plastic housing of the machine using
a soft brush and clean cloth. Do not use water, solvents
or polishes. Remove all debris, especially from the motor
cooling vents.
Store in a secure, dry place out of the reach of children.
Do not place other objects on the product.
FOR BATTERY TOOLS:
The ambient temperature range for tool and battery use
and storage is 0
o
C-45
o
C.
The recommended ambient temperature range for the
charging system during charging is 0
o
C-40
o
C.
EN
Publicité
