Publicité
E3: Flow is not detected.
Note:
– The normal operating range of the flow sensor is between 2m
– If the daily filtration time is divided into several ranges and the times of the ranges are shorter than
the treatment time then this error may appear temporarily during the pauses between the ranges until
the treatment time is completed on the subsequent ranges.
Solution:
• Check that the filtration time is long enough to cover the entire treatment time.
• Check that the bypass allows enough water to pass through the cell and that the valves are set
correctly.
• Check that the filter is not clogged (if necessary, clean it).
• Check that the pump has sufficient flow
• Check that there is no debris or scale in the cell that could jam the sensor (clean it if necessary
«Cleaning the cell», page 36).
If all the above steps have been followed but the error persists, contact the after-sales service for a
possible replacement of the flow sensor.
E5: Salt content is too low.
Note: The normal operating range for salt concentration is 2700 to 4500 ppm.
Solution: Check the salt concentration measurement.
If necessary, add salt up to 3 g/l, as follows «Adding salt», page 30.
Once the correct level has been reached, the chlorinator should operate normally again.
E7: Total temperature sensor error
Solution: Contact SAV for a possible replacement of the temperature sensor.
E8
: Transformer output voltage error
Solution: Contact customer support for a replacement transformer.
E9: Output current error
Solution: Contact customer support for a replacement transformer or cell.
EA: Cell error
Solution:
• Check salt concentration. Correct if necessary.
• If error persists, contact customer support for a replacement cell.
EC: Electronics error
Solution:
• Unplug the transformer, wait one minute, then plug back in.
• If error persists, contact customer support for replacement electronic cards.
|
40
EN
REPAIRS
/h and 10m
/h.
3
3
The YZAKI salt chlorinator is guaranteed free of any material or manufacturing defects, for normal use
and non-commercial applications, for a period of five (5) years or 10,000 h, subject to the following
conditions:
• Proof of purchase is required.
• This limited warranty applies to the casing and the generating cell.
• This limited warranty extends exclusively to the original purchaser of the chlorinator system and is
non-transferable.
• The YZAKI salt chlorinator is intended for use in private pools and any commercial use voids this
warranty.
This warranty does not apply to the following situations:
• Malfunction or damage resulting from installation, use or repair that does not comply with the safety
instructions.
• Faults or damage arising from improper use of the chlorinator pursuant to the manufacturer's
recommendations, as set out in this User Guide.
• Malfunction or damage deriving from an unsuitable chemical environment of the swimming pool.
• Faults arising from failure to maintain the chemical properties of the pool at the appropriate levels,
pursuant to the manufacturer's recommendations set out in this User Guide.
• Faults or damage arising from sabotage, accidents, electrical surges, abuse, negligence, unauthorised
or unqualified repairs, alterations to the product, or damage due to fire, floods or frost, acts of God
or force majeure.
• Malfunction or damage resulting from conditions unsuitable for the intended use of the device.
• Damage resulting from negligence, accident or force majeure.
• Malfunction or damage deriving from the use of unauthorized accessories.
• Damage or deterioration of concrete, natural stone, wood or synthetic surfaces nearby the pool.
Legal disclaimer: this limited
warranty constitutes the entire warranty.
No other guarantees apply, explicit or implicit. This limited warranty grants specific legal rights which may
vary by jurisdiction. Under no circumstances shall we be liable for consequential damage(s), special or
indirect, regardless of nature, including but not limited to physical injury, property damage, or damage
or loss of equipment. The agent / installer shall not be liable for any costs arising from installation or
maintenance.
Repairs covered during the warranty period must be approved before they are performed by an authorized
technician. This warranty is void in the event of repairs to the device made by individuals which have not
been authorised. The parts under warranty shall be replaced or repaired at the discretion of Poolstar.
Faulty parts must be returned to us during the warranty period in order to be covered. The warranty does
not cover unauthorised replacements or labour costs. Delivery costs for returning the faulty part are not
covered by the warranty.
c
ontacting customer suPPort
Please contact the after-sales service directly in the shop where you purchased your product to
make your request.
WARRANTY
|
EN
41
Publicité
