Trouble Shooting Guide - AEG KWK884520M Manuel Utilisateur

12 www.aeg.com
8.

TROUBLE SHOOTING GUIDE

You can solve many common Wine cellar
problems easily, saving you the cost of a
possible service call. Try the suggestions.
Problem
Wine cellar
does not
operate.
Wine cellar
is not cool
enough.
The
compressor
operates
continuously.
The light
does not work.
Too much
vibration.
Too much
noise.
The door does
not close
properly.
Acoustic alarm
E3 is displayed
E1 is displayed
and an acoustic
alarm will sound
every 5 minutes.
E2 is displayed
Possible cause
• Not plugged in.
• The appliance is turned off.
• The circuit breaker tripped.
• Demo Mode is active.
• Check the temperature control setting.
• The door is not completely closed.
• The door gasket does not seal properly.
• The room temperature is hotter than
normal.
• The door is opened too often.
• The door is not completely closed.
• The door gasket does not seal properly.
• Not plugged in.
• The circuit breaker tripped.
• The LED has burned out.
• The light button is not operating.
• Check that the wine cellar is levelled.
• The rattling noise may co me from the flow
of the refrigerant, which is normal.
• Contraction and expansion of the inside walls
may cause popping and crackling noises.
• The wine cellar is not level.
• Fan is dirty.
• The wine cellar is not level.
• The door was fixed not properly.
• The gasket is dirty.
• The door is not closed (the alarm lasts
30 min).
• The door was left open for more than
30 min.
• Door reed switch is broken.
• The temperature inside the wine cellar
is outside the range of -20°C +60°C
• The temperature sensor is out of order
or disconnected.
• Warm coming from nearest appliances.
• Ambient temperature is out of the
product climate class Range.
• Compressor or fan are out of order.
Solution
• Please connect the appliance.
• Please turn ON the appliance.
• Turn on the circuit breaker.
• Deactivate the Demo mode (press +/- for 3sec.).
• Verify the set temperature.
• Verify the closure of the door.
• Clean the door gasket with a humid sponge
using neutral detergent and water.
• Verify the room temperature.
• Do not keep the door open longer than necessary.
• Verify that the door is completely closed.
• Verify the gasket condition and in case clean it with
a humid sponge using neutral detergent and water.
• Please connnect the appliance.
• Turn on the circuit breaker.
• Contact the service.
• Contact the service.
• Level the appliance.
• Level the appliance.
• Clean the fan from powder.
• If the noises become louder contact the
service.
• Level the appliance.
• Verify the closure of the door.
• Clean the door gasket with a humid sponge
using neutral detergent and water.
• Close the door.
• Close the door.
• Contact the service.
• Verify absence of heating from nearest
appliances.
• Contact the service.
• Verify absence of heating from nearest appliances.
• Verify if the product is installed in a place with
ambient temperature within declared product
climate class.
• Contact the service.