Publicité
INSTALLING THE WASHER
1. Run some water from the hot and cold faucets to flush
the water lines and remove particles that might clog up
the water valve screens.
2. Remove the inlet hoses from the plastic bag.
3. (90° elbow end)
Carefully connect the inlet
hose marked HOT to the
outside "H" outlet of the
water valve. Tighten by
hand, then tighten another
2/3 turn with pliers.
Carefully connect the other
inlet hose to the inside "C"
outlet of the water valve.
Tighten by hand; then tighten another 2/3 turn with
pliers. Do not crossthread or over-tighten these
connections.
4. Connect the inlet hose ends to the HOT and COLD
water faucets tightly by hand, then tighten another 2/3
turn with pliers. Turn the water on and check for leaks.
Installation Instructions
5. Carefully move the washer to its final location. Gently
rock the washer into position. It is important not to
damage the rubber leveling legs when moving your
washer to its final location. Damaged legs can increase
washer vibration. It may be helpful to spray window
cleaner on the floor to help move your washer into its
final position. NOTE: To reduce vibration, ensure that
all four rubber leveling legs are firmly touching the
floor. Push and pull on the back right and then back
left of your washer.
NOTE: Do not use the dispenser drawer or door to lift
the washer.
NOTE: If you are installing into a drain pan, you can
use a 24-inch long 2x4 to lever the washer into place.
6. With the washer in its
final position, place a
level on top of the
washer (if the washer
is installed under a
counter, the washer
should not be able to
rock). Adjust the front
leveling legs up or down to ensure the washer is
resting solid. Turn the lock nuts on each leg up
towards the base of the washer and snug with a
wrench.
NOTE: Keep the leg extension at a minimum to
prevent excessive vibration. The farther out the
legs are extended, the more the washer will vibrate.
If the floor is not level or is damaged, you may have
to extend the rear leveling legs.
18
Publicité
