Instruction Manual - Seatec TARGET Mode D'emploi

Instruction Manual

Never look directly at the sun with the
binoculars. This may cause burn injuries
to the retina.
A Individual eyepiece adjustment
2 Rubber eyecup
3 Compass
4 Battery compartment
5 Compass lighting ON/OFF button
6 Rotating distance calculation scale
7 Threaded tripod connection
8 Reticule
Setting the distance between the eyes
The distance between the eyes differs between individu-
als. To achieve optimal centring of the eye and eyepiece
axis look through the binoculars and change the angle
of the centre axis by folding or expanding until you have
a clear field of view.
GB/IR
Adjusting the focus
Your binoculars have single eyepiece adjustment A
means. To focus look at an object approximately 100
meters away. Close only your left eye and keep turning
the right eyepiece setting ring 1 until the object looked
at is in sharp focus. Then close only your right eye and
turn the left eyepiece setting 1 until the object you are
looking at is again in sharp focus. The binoculars are
now precisely adjusted to your eyesight.
The single eyepiece setting A is designed to give you
better perspective. When switching between objects of
varying distance the focus need only be readjusted if
the change in distance is really major.
Reversing the eye-piece cup
Note for spectacles wearers. The rubber eyepiece cups
2 are reversed when using spectacles to look through
the binoculars. The maximum field of view of the binoc-
ulars can thus be exploited to the full.
Compass 3
Your binoculars are equipped with a compass. If you
look through them you will see a scale in degrees
(350...360...) at the lower edge of your field of view. If
360 is exactly at the centre of the scale you are looking
directly to the north (if 180, to the south).
- 6 -