Publicité
Liens rapides
No-Drill MudFlaps
1
Start by thoroughly washing your vehicle. Take
care to remove all dirt, debris, and stains from
each fender in the areas corresponding to
where the MudFlaps will be installed.
2
Park the vehicle on level ground. Begin with
the driver's side MudFlap installation.
3
3
Locate the (2) two factory Torx head screws at the
inner fender as indicated.
5
5
Using the MudFlap marked "LH," place it up to the
fender and align with the corresponding holes.
Installation Instructions
4
4
Using a ratchet and appropriate socket, remove the
(2) two factory Torx head screws at the inner fender.
They will be reused.
6
6
Using the ratchet and appropriate socket, re-install
the (2) two previously removed factory Torx head
screws and install through the holes in the MudFlap.
Then, tighten to a snug fit.
What You Need
Ratchet and Socket Set*
*Not included
48MF124 Parts Kit:
(1) Torx Bit
Publicité
Manuels Connexes pour WeatherTech No-Drill MudFlaps
Sommaire des Matières pour WeatherTech No-Drill MudFlaps
- Page 1 Installation Instructions No-Drill MudFlaps What You Need Ratchet and Socket Set* *Not included Start by thoroughly washing your vehicle. Take care to remove all dirt, debris, and stains from each fender in the areas corresponding to where the MudFlaps will be installed.
- Page 2 (2) two factory Torx head screws. repeating Steps 3-7. Congratulations! Your new WeatherTech® No-Drill MudFlaps have been installed! Your WeatherTech® No-Drill MudFlap carries a Lifetime Limited Warranty against defects in materials and workmanship when installed correctly. WARNING: The MudFlap is designed to fit vehicles with standard-sized wheels and tires.
- Page 3 Lo que necesita Matériel nécessaire Juego de matraca Trousse de douilles y dados* et rochet* No-Drill MudFlaps *No incluida * Non compris Instrucciones de instalación Lo que necesita Matériel nécessaire Juego de piezas Trousse de pièces Instructions 48MF124: 48MF124 : d’installation (1) punta Torx (1) embout Torx Estacione el vehículo en terreno plano.
- Page 4 « RH » en répétant les étapes 3 à 7. l’aile, vissez complètement les deux (2) vis à tête Torx d’usine. ¡Felicitaciones! ¡Sus nuevas Loderas Sin-Perforacion de WeatherTech® están instaladas! Cuando se instalan correctamente, incluyen una garantía limitada de por vida contra defectos de materiales y mano de obra.