Changing The Carbon Brushes; Repair; Warranty; Storage - Bevel Tools Mate EBA - 12 Mode D'emploi

4.1.1 Changing the carbon brushes

The Automatic-Stop feature protects the machine from defects due to excessively consumed carbon brushes. The
machine is equipped with two carbon brushes, i.e. one is installed in each handle half.
The carbon brushes must be changed as follows:
• Unscrew four screws and remove the handle halves.
• Lift spring with screwdriver and remove brush.
• Install new brushes.
• Clean carbon brush holders, making absolutely sure not to change the arrangement of the elements of the carbon
brush assembly.
• Fit handle halves and fasten with four screws.
• Repeat this on the opposite side, making absolutely sure to avoid both handle halves from being opened at the same
time.

4.2 Repair

If despite strict observance of the manufacturing and testing method the tool should happen to fail, it must
be repaired by an authorized agency. Any replacement needed for the connecting line must be installed by the
manufacturer or its agent if safety risks are to be eliminated.

4.3 Warranty

i
Beveltools machines have been manufactured to quality standards and carefully inspected before shipment. The
warranty period for all Beveltools machines is 12 months from the original date of purchase. If repair is required,
the user must return the complete tool to the manufacturer or nearest authorized dealer. Complaints can only be
honoured if the machine is returned in the undissembled condition, with copy of the purchase invoice and clear
description of the problem. If inspection shows an original defect in material or workmanship Beveltools will repair or
replace the tool without charge during the warranty period.
The warranty does not apply to normal use or wear and tear. In the event of the tool being improperly handled, used
for purposes for which it is not intended and/or if the service and maintenance instructions not being observed by
authorized persons, no warranty shall be in effect for damages/consequential damages.
Beveltools reserves the right to make changes or improvements to its products. Beveltools is not obligated to make
any corresponding changes or improvements in products previously manufactured or sold.

4.4 Storage

Temperature range during operation
Max. relative air humidity

4.5 Disposal / environmental compatibility

This machine consists of materials which can be disposed of in a recycling process. Before disposal, render the
machine unusable. Do not throw the machine into the garbage collection. According to national regulations this
machine must be disposed of in an environmentally compatible recycling process.
EN
-15°C up to +50°C
90 % at + 30°C
65 % at + 50°C
6